Changeset b1674ed in flex_extract.git for For_developers/Sphinx/source/Documentation/vertco.rst

Timestamp:

Apr 1, 2020, 5:03:13 PM (4 years ago)

Author:

Anne Philipp <anne.philipp@…>

Branches:

master, ctbto, dev

Children:

d78851d, e0005c9

Parents:

50f9ca6

Message:

updated online documentation FIX for tickets #265 and #262

File:

• For_developers/Sphinx/source/Documentation/vertco.rst (modified) (2 diffs)

For_developers/Sphinx/source/Documentation/vertco.rst

@@ -23 +23 @@
 ===================================================================================
 
-The vertical velocity is computed by the FORTRAN90 program ``CONVERT2`` in the ECMWF
-vertical coordinate system by applying the equation of continuity and thereby ensuring mass consistent 3D wind fields. A detailed description of ``CONVERT2`` can be found in the
+The vertical velocity is computed by the FORTRAN90 program ``calc_etadot`` in the ECMWF
+vertical coordinate system by applying the equation of continuity and thereby ensuring mass consistent 3D wind fields. A detailed description of ``calc_etadot`` can be found in the
 documents v20_update_protocol.pdf, V30_update_protocol.pdf and
-V40_update_protocol.pdf. The computational demand and accuracy of ``CONVERT2`` is highly
+V40_update_protocol.pdf. The computational demand and accuracy of ``calc_etadot`` is highly
 dependent on the specification of parameters ``GAUSS``, ``RESOL`` and ``SMOOTH``. The
 following guidance can be given for choosing the right parameters:
@@ -45 +45 @@
 ======================================================================
 
-Since November 2008, the parameter 77 (deta/dt) is stored in ``MARS`` on full model levels. ``FLEXTRA``/``FLEXPART`` in its current version requires ``deta/dt`` on model half levels, multiplied by ``dp/deta``. In ``flex_extract``, the program ``CONVERT2`` assumes that this parameter is available if the ``CONTROL`` parameter ``ETA`` is set to 1. 
+Since November 2008, the parameter 77 (deta/dt) is stored in ``MARS`` on full model levels. ``FLEXTRA``/``FLEXPART`` in its current version requires ``deta/dt`` on model half levels, multiplied by ``dp/deta``. In ``flex_extract``, the program ``calc_etadot`` assumes that this parameter is available if the ``CONTROL`` parameter ``ETA`` is set to 1. 
 
 It is recommended to use the pre-calculated parameter 77 by setting ``ETA`` to 1 whenever possible.